General Specifications |
Specification |
Description |
Projector type |
1-Chip DLP projector |
DLP chip | Display method |
DLP chip x 1, DLP projection system |
DLP chip | Number of Pixels |
2,304,000 (1920 × 1200) pixels |
Light source |
Laser diodes |
Resolution |
4,608,000 pixels / 2715 x 1697 dots With Smooth Pixel Drive: ON. |
Screen size [diagonal] (mm) |
1.27–15.24 m (50–600 in), 1.27–5.08 m (50–200 in) with ET-DLE055, 2.54–8.89 m (100–350 in) with ET-DLE035, 16:10 aspect ratio |
Screen size [diagonal] (inch) |
1.27–15.24 m (50–600 in), 1.27–5.08 m (50–200 in) with ET-DLE055, 2.54–8.89 m (100–350 in) with ET-DLE035, 2.54–10.16 m (100–400 in) with ET-DLE020, 16:10 aspect ratio |
LENS |
PT-RCQ10: Powered zoom (throw ratio 1.71–2.41:1), powered focus F 1.7–1.9, f 25.6–35.7 mm |
PT-RCQ10L: Optional powered zoom/focus lenses |
Keystone correction range |
Vertical: ±40° (±5° with ET-DLE020, ±16° with ET-DLE060, ±22° with ET-DLE105/ET-DLE085/ET-DLE055, +5° with ET-DLE035), Horizontal: ±15° (±10° with ET-DLE060) (cannot be operated with ET-DLE035/ET-DLE020) |
Keystone correction range with optional ET-UK20 Upgrade Kit |
Vertical: ±45° (±16° with ET-DLE060, ±40° with ET-DLE150/ET-DLE250/ET-DLE170, ±22° with ET-DLE105/ET-DLE085/ET-DLE055), Horizontal: ±40° (±10° with ET-DLE060, ±15° with ET-DLE105/ET-DLE085/ET-DLE055), When [VERTICAL KEYSTONE] and [HORIZONTAL KEYSTONE] are used simultaneously, correction cannot be made exceeding a total of 55°. |
Installation |
Ceiling/floor, front/rear, free 360-degree installation |
Terminals | SDI IN |
BNC x 1: 3G/HD-SDI input |
Terminals | HDMI IN |
HDMI 19-pin x 1 (Deep Color, compatible with HDCP 2.2, 4K/60p signal input ) |
Terminals | DVI-D IN |
DVI-D 24-pin x 1 (DVI 1.0 compliant, compatible with HDCP, compatible with single link only) |
Terminals | MULTI PROJECTOR SYNC IN |
BNC x 1 |
Terminals | MULTI PROJECTOR SYNC OUT |
BNC x 1 |
Terminals | SERIAL IN |
D-sub 9-pin (female) x 1 for external control (RS-232C compliant) |
Terminals | SERIAL OUT |
D-sub 9-pin (male) x 1 for link control |
Terminals | REMOTE 1 OUT |
M3 x 1 for link control (for wired remote control) |
Terminals | REMOTE 2 IN |
D-sub 9-pin (female) x 1 for external control (parallel) |
Terminals | LAN |
RJ-45 x 1 for network connection, 10Base-T/100Base-TX, compliant with PJLink (Class 2), Art-Net |
Terminals | Expansion Slot |
Open slot for SLOT NX compatible interface board |
Power supply |
AC 100-240 V, 50/60 Hz |
Power consumption |
1,100 W |
Cabinet materials |
Molded plastic |
Operation noise |
43 dB (Normal)/40 dB (Quiet 1)/38 dB (Quiet 2) |
Operating environment |
Operating temperature: 0–45 °C (32–113 °F) , operating humidity: 10–80 % (no condensation) |
Applicable software |
Logo Transfer Software, Multi Monitoring & Control Software, Early Warning Software, Geometry Manager Pro (ET-UK20 Upgrade Kit, ET-CUK10 Auto Screen Adjustment Kit), Smart Projector Control for iOS/Android |
Note |
1. Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118: 2012 international standards. Value is the average of all products when shipped.
2. Average light-output value of all shipped products measured at the center of the screen in NORMAL Mode.
3. Around this time, the light output will have decreased by approximately 50 %. IEC62087: 2008 Broadcast contents, NORMAL Mode, [Dynamic Contrast] set to [3], under conditions with 30 °C (86 °F), 700 m (2,297 ft) above sea level, and 0.15 mg/m3 of particulate matter. The estimated time until light output declines to 50 % varies depending on the environment.
4. Lens shift is not supported on the ET-DLE055, and the optical axis is fixed with the ET-DLE035.
5. 4K input signals are resized to 2715 x 1697 pixels upon projection. (With Smooth Pixel Drive: ON)
6. With legs at the shortest position.
7. Average value. It May differ depending on the actual unit.
8. When using the projector at an altitude lower than 2,700 m (8,858 ft) above sea level, and the operating environment temperature becomes 30 °C (86 °F) or higher, the light output may be reduced to protect the projector. When using the projector at an altitude between 2,700 m (8,858 ft) and 4,200 m (13,780 ft), and the operating environment temperature becomes 25 °C (77 °F) or higher, the light output may be reduced to protect the projector.
9. When optional AJ-WM50 wireless module is attached, the operating temperature range becomes 0–40 °C (32–104 °F). |
Terminals | REMOTE 1 IN |
M3 x 1 for wired remote control |
Contrast Ratio |
10,000:1 (Full On/Full Off) With [Dynamic Contrast] set to [3] |
Terminals | USB |
USB Connector (Type A) x 1 for Cloning/Wireless Module (output 5 V/500 mA) |
Center-to-corner zone ratio |
90% |
Terminals | DIGITAL LINK |
RJ-45 x 1 for network, DIGITAL LINK connection (HDBaseT compliant), 100Base-TX, compatible with Art-Net, PJLink (Class 2), Deep Color, HDCP 2.2, 4K/60p signal input |
Time until light output declines to 50 % |
20,000 hours (NORMAL) / 24,000 hours (ECO) |
Lens shift | Vertical (from center of screen) |
+50 %, -16 % (+40 %, -16 % with ET-DLE060) (powered) |
Lens shift4 | Horizontal (from center of screen |
+30 %, -10 % (+10 %, -20 % with ET-DLE020, +19 %, -10 % with ET-DLE060, +28 %, -10 % with ET-DLE105/ET-DLE085) (powered) |
Weight |
PT-RCQ10: Approx. 24.2 kg (53.4 lbs) (with supplied lens) |
PT-RCQ10L: Approx. 23.4 kg (51.6 lbs) (without lens |
Light output |
10,000 lm / 10,500 lm (Center) |
Dimensions (W x H x D) |
PT-RCQ10: 498 x 200*6 x 581 mm (19 19/32˝ x 7 7/8˝ *6 x 22 7/8˝ ) (with supplied lens) |
PT-RCQ10L: 498 x 200*6 x 538 mm (19 19/32˝ x 7 7/8˝ *6 x 21 3/16˝ ) (without lens) |
DLP chip | Panel size |
17.0 mm (0.67 in) diagonal, 16:10 aspect ratio |
Reviews
Clear filtersThere are no reviews yet.